One Crown Studio Refrence 1 amp. Overall condition is far above average based on the others I have seen for sale. The side and backs are good, the bottoms have scratches as there are no feet.
It is an outstanding amp when run in stereo and in mono. The dampening factor is <20,0000. Over 2000 watts in mono 2 ohms and handle 1 ohm with ribbons (Apogee Full Range) and electrostats. These are great sounding amplifiers.
I am the 2nd owner, the box, packing, amp & manual are in great shape, no shipping labels on box. I have the FX card for xlr input.. Will include the 30 amp adapter plug for standard 15 amp outlet,
It was into a factory service shop for a turn on transisitor. that needed updated. and again for a hum that ended up being my cable, not the amp.
I prefer to sell as pick up.
I have a 2nd in equally good condition that can be offered for sale if interested in a pair.
https://www.crownaudio.com/en/site_elements/studio-reference-manual
Studio Reference
Stereo mode (with both channels driven):
1,160 watts into 4 ohms.
780 watts into 8 ohms.
Bridge-Mono mode:
2,220 watts into 8 ohms.
1,580 watts into 16 ohms.
Parallel-Mono mode:
2,315 watts into 2 ohms.
1,565 watts into 4 ohms.
Frequency Response: ±0.1 dB 20 Hz to 20 kHz at 1 watt
(see Figure 6.5).
Phase Response: +5 to –15 degrees from 20 Hz to
20 kHz at 1 watt (see Figure 6.8).
Signal-to-Noise: (A-weighted)
Studio Reference : Greater than 120 dB below rated
full bandwidth power.
Total Harmonic Distortion (THD): Less than 0.02% at
rated low-distortion 1 kHz power. Less than 0.1% at rated
full bandwidth power.
Intermodulation Distortion (IMD): (60 Hz and 7 kHz 4:1)
Studio Reference : Less than 0.005% from full bandwidth
power to 78 watts rising linearly to 0.025% at
78 milliwatts.
Damping Factor: Greater than 20,000 from 10 Hz to
200 Hz, and greater than 2,500 at 1 kHz (see Figure 6.6).
Crosstalk:(At rated full bandwidth power)
Studio Reference : Better than 100 dB from 20 Hz to
100 Hz falling linearly to better than 70 dB at 20 kHz
(see Figure 6.10).
Common Mode Rejection (CMR): (At rated full bandwidth
power) See Figure 6.9.
Voltage Gain: (With level controls set for maximum output)
At the 26 dB gain setting, 20:1 ±3% or 26 dB ±0.25 dB.
Studio Reference : At 0.775 volt sensitivity, 103:1
±12% or 40 dB ±1 dB; at 1.4 volt sensitivity 57:1 ±12%
or 35 dB ±1 dB.
Includes:
one amp, factory box and packing, Orignial manual, adapter, bridging plug, FX XLR card.