One pair of Crown Studio Refrence 1 amps. Overall condition is far above average based on the others I have seen for sale. There are a few touched up scratches and one small dent on top of one amp. The side and backs are good, the bottoms have scratches as there are no feet.
They are outstanding amps when run in stereo and even better in mono. The dampening factor is <20,0000. Over 2000 watts in mono 2 ohms and handle 1 ohm with ribbons (Apogee Full Range) and electrostats. These are great sounding amplifiers.
I am the 2nd owner, the boxes, packing, & manuals are in great shape, no shipping labels on boxes. I have the FX cards for xlr input, however I used 1/8" cables. They will include the 30 amp adapter plugs for standard 15 amp outlets,
They were into a factory service shop for a turn on transisitor. that needed updated. and again for a hum that ended up being my cable, not the amps.
I prefer to sell as pick up.
Studio Reference
Stereo mode (with both channels driven):
1,160 watts into 4 ohms.
780 watts into 8 ohms.
Bridge-Mono mode:
2,220 watts into 8 ohms.
1,580 watts into 16 ohms.
Parallel-Mono mode:
2,315 watts into 2 ohms.
1,565 watts into 4 ohms.
Frequency Response: ±0.1 dB 20 Hz to 20 kHz at 1 watt
(see Figure 6.5).
Phase Response: +5 to –15 degrees from 20 Hz to
20 kHz at 1 watt (see Figure 6.8).
Signal-to-Noise: (A-weighted)
Studio Reference : Greater than 120 dB below rated
full bandwidth power.
Total Harmonic Distortion (THD): Less than 0.02% at
rated low-distortion 1 kHz power. Less than 0.1% at rated
full bandwidth power.
Intermodulation Distortion (IMD): (60 Hz and 7 kHz 4:1)
Studio Reference : Less than 0.005% from full bandwidth
power to 78 watts rising linearly to 0.025% at
78 milliwatts.
Damping Factor: Greater than 20,000 from 10 Hz to
200 Hz, and greater than 2,500 at 1 kHz (see Figure 6.6).
Crosstalk:(At rated full bandwidth power)
Studio Reference : Better than 100 dB from 20 Hz to
100 Hz falling linearly to better than 70 dB at 20 kHz
(see Figure 6.10).
Common Mode Rejection (CMR): (At rated full bandwidth
power) See Figure 6.9.
Voltage Gain: (With level controls set for maximum output)
At the 26 dB gain setting, 20:1 ±3% or 26 dB ±0.25 dB.
Studio Reference : At 0.775 volt sensitivity, 103:1
±12% or 40 dB ±1 dB; at 1.4 volt sensitivity 57:1 ±12%
or 35 dB ±1 dB.
Includes:
two amps, factory boxes and packing, Orignial manuals, adapters, bridging plug, FX XLR cards.